Review Conflict Procedure

To review configuration changes from the FDM-managed device, follow this procedure:

Procedure

Step 1

In the left pane, click Inventory.

Step 2

Click the Devices tab.

Step 3

Click the appropriate device type tab.

Step 4

Select the device whose configuration is marked Conflict Detected and gives you a link to Review Conflict in the Conflict Detected pane on the right.

Step 5

Click Review Conflict.

Step 6

Compare the two configurations presented to you.

Step 7

Take one of these actions:

Click Accept to overwrite the last known configuration on CDO with the one found on the device. Note: The entire configuration stored on CDO will be completely overwritten by the configuration found on the device.
Click Reject to reject the changes made on the device and replace them with the last known configuration on CDO.
Click Cancel to stop the action.

Note	You can prompt CDO to immediately check a device for an out-of-band change by clicking Check for Changes while the device is in the Synced state.