Deploy Configuration Changes Made Using the CDO GUI

Procedure

Step 1

After you make a configuration change using the CDO GUI and save your change, that change is saved in CDO's stored version of the ASA's running configuration file.

Step 2

Return to the device on the Inventory page.

Step 3

Click the Devices tab. You should see that the device is now "Not synced."

Step 4

Deploy the changes using one of these methods:

  • Click the Deploy icon at the top-right of the screen. This gives you a chance to review the changes you made to the device before you deploy them. Check the device you made changes to, expand the device to review the changes, click Deploy Now to deploy the changes.

    Note

    If you see a yellow warning triangle next to your device on the Devices with Pending Changes screen, you cannot deploy a change to it. Hover your mouse over the warning triangle to learn why you can't deploy changes to the device.

  • In the Not Synced pane, click Preview and Deploy....

    1. Review the commands that will change the ASA configuration file.

    2. If you are satisfied with the commands, choose a Configuration Recovery Preference.

      Note

      If you choose "Let me know and I will restore the configuration manually." click View Manual Synchronization Instructions before continuing.

    3. Click Apply Changes to Device.

    4. Click OK to acknowledge the success message.